CDTooling TYPE 2302 TWO STRAIGHT FLUTES

Maximum chip room for easier chip removal.

Also used when machine horsepower is too low for higher capacity end mills.
Flute long carbide tips brazed to hardened alloy steel bodies.
Cutting diameter NC tolerance plus .002" minus .000".
Straight shanks with drive flats.

USE:

For milling cast iron, non-ferrous metals and non-metals but excluding steel.

OPTIONS

Intermediate decimal cutting diameters.
Radius end.
End chamfer.
Undersize shank diameters.

CDTooling TYPE 2304 — STRAIGHT FLUTES

Where the machine horsepower permits a higher capacity

end mill - feeds less than .002" per flute per 

revolution may result in fast dulling of cutting edges.
Flute long carbide tips brazed to hardened alloy steel bodies.
Cutting diameter NC tolerance plus .002" minus .000".
Straight shanks with drive flats.

USE:

For milling cast iron, non-ferrous metals and non-metals but excluding steel.

OPTIONS

Intermediate decimal cutting diameters.
Radius end.
End chamfer.
Undersize shank diameters.

CDTooling TYPE 2306 — 6° RIGHT SPIRAL FLUTES

The spiral flutes capacity to remove chips permits heavier feeds and faster speeds, 

especially on free cutting zinc and aluminum.

Flute long carbide tips brazed to hardened alloy steel bodies.
Cutting diameter NC tolerance plus .002" minus .000".
Straight shanks with drive flats.

USE:

For milling cast iron, non-ferrous metals and non-metals but excluding steel.

OPTIONS

Intermediate decimal cutting diameters.
Radius end.
End chamfer.
Undersize shank diameters.